NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
7-2 Mode-based CLI
202-10102-01, May 2005
VLAN Mode From the Privileged
User Exec mode, enter
the vlan database
command.
Switch (Vlan) # To exit to the Privileged
Exec mode, enter the
exit command, or press
Ctrl-Z to switch to user
exec mode.
Global Config Mode From the Privileged
Exec mode, enter the
configure command.
Switch (Config)# To exit to the Privileged
Exec mode, enter the
exit command, or press
Ctrl-Z to switch to user
exec mode.
Interface Config Mode From the Global
Configuration mode,
enter the
interface
config <slot/port>
command.
Switch (Interface-"if
number")#
To exit to the Global
Config mode enter exit.
To return to user EXEC
mode enter ctrl-Z.
Line Config Mode From the Global
Configuration mode,
enter the
lineconfig
command.
Switch (line) # To exit to the Global
Config mode enter exit.
To return to User Exec
mode enter ctrl-Z.
Policy Map Mode From the Global
Configuration mode,
enter the
policy map
command.
Switch (Config-policy-
map)#
To exit to the Global
Config mode enter exit.
To return to user EXEC
mode enter ctrl-Z.
Policy Class Mode From the Policy Map
mode enter the
class
command.
Switch (Config-policy-
classmap)#
To exit to Policy Map
mode enter exit. To
return to User Exec
mode enter ctrl-Z.
Class Map Mode From the Global Config
mode, enter the
class-
map
command.
Switch (Config-class-
map)#
To exit to Global Config
mode enter exit. To
return to User Exec
mode enter ctrl-Z.
Router Config RIP
Mode
From the Global Config
mode, enter the
router
rip command
Switch (Config-router)# To exit to the Global
Config mode enter exit.
To return to User Exec
mode enter ctrl-Z.
DHCP Pool
Configuration Mode
From the Global
Configuration mode,
enter the
ip dhcp pool
<pool-name>
command.
Routing (Config-dhcp-
pool)
To exit to Global
Configuration mode
enter exit. To return to
user EXEC mode, enter
ctrl-Z
Table 7-1. Command Mode (continued)
Command Mode Access Method Prompt
Exit or Access Next
Mode