Oce plotwave 345 User Manual

Preset Settings values Settings values Function
[Area to
erase]
[Area to erase: X
origin]
From 0 to 914 mm or
0 to 36".
[The horizontal offset where the
erase area starts.]
[Area to erase: Y
origin]
From 0 to 6000 mm or
0 to 250".
[The vertical offset where the erase
area starts.]
[Area to erase:
width]
From 0 to 914 mm or
0 to 36".
[The width of the area to erase.]
[Area to erase:
length]
From 0 to 6000 mm or
0 to 250".
[The length of the area to erase.]
Preset category: [Finishing]
Preset Settings values Function
[Delivery] [Top Delivery Tray] Location on top of the printer that deposits the
sheet face-down.
NOTE
Not all media types can be delivered
to the [Top Delivery Tray].
[Back output] Location at the back of the printer that deposits
the sheet face-up.
[Fold] [On]
[Off]
When enabled and a finisher is installed, you
can fold your output.
Advanced settings for copy jobs
Chapter 4 - Use the Printing System
175

Oce plotwave 345 Specifications

General

Resolution	600 x 1200 dpi
Memory	4 GB
Hard Drive	500 GB
Print Technology	Electrophotography LED
Print Speed	6 A1/D prints per minute
Media Handling	Rolls
Maximum Media Width	36 inches
Technology	Océ Radiant Fusing
Media Width	Up to 36 inches
Roll Capacity	Up to 2 rolls
Media Length	Up to 18.3 m (60 ft)