Setting the Output Conditions
ZW-7000/5000
User's Manual
227
Sensor controller operations
7
Performing Hold with a Key Input
Press the / key on the Sensor Controller to enable the TIMING or RESET input.
• TIMING input is ON while the key is pressed.
•
• RESET input is ON when the key is pressed.
Note that the key input is disabled in the default setting. Set the following when using this function.
Steps Key operation Display Description
1 Press and hold the key for two seconds to enter the FUNC
mode.
2 Press the / keys to select “SYSTEM” and press the
key.
3 Press the / keys to select “KEY.IN” and press the
key.
4 Enable the key input.
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
Select “ON” and press the
key.
5 Press the key for two seconds to enter the RUN mode.
The above settings are also possible using the personal computer tools.
Performing Hold with a Key Input p.150
Note
To Next Page
Loading...
