R&S ESR Series User Manual

Remote Control
R&S
®
ESR
930User Manual 1175.7068.02 ─ 12
INSTrument:COUPle:PRESel <State>
This command turns synchronization of the preselector state between measurement
channels on and off.
Note that it is not possible to turn off the preselector in receiver mode. Thus, the prese-
lector is always turned on when you enter receiver mode.
Parameters:
<State> ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: ALL
Example:
INST:COUP:PRES ALL
Synchronizes the preselector configuration.
INSTrument:COUPle:PROT
<State>
This command turns synchronization of the input protection between measurement
channels on and off.
(➙ 10 dB Min)
Parameters:
<State> ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: NONE
Example:
INST:COUP:PROT ALL
Synchronizes the "10 dB Min" parameter.
INSTrument:COUPle:SPAN <State>
This command turns synchronization of the start and stop frequency between mea-
surement channels on and off.
Parameters:
<State> ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: NONE
Example:
INST:COUP:SPAN ALL
Synchronizes the start and stop frequency.
System Configuration

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English