R&S ESR Series

Remote Control
R&S
®
ESR
915User Manual 1175.7068.02 ─ 12
Parameters:
<Name> Generator name | NONE
*RST: NONE
Example:
SYST:COMM:RDEV:GEN2:TYPE 'SME02'
Selects SME02 as generator 2
Mode: A, NF
Manual operation: See "Type" on page 490
11.8 Common Commands
Common commands are described in the IEEE 488.2 (IEC 625-2) standard. These
commands have the same effect and are employed in the same way on different devi-
ces. The headers of these commands consist of "*" followed by three letters. Many
common commands are related to the Status Reporting System.
Available common commands:
*CAL?...........................................................................................................................915
*CLS.............................................................................................................................916
*ESE.............................................................................................................................916
*ESR?...........................................................................................................................916
*IDN?............................................................................................................................916
*IST?............................................................................................................................ 916
*OPC............................................................................................................................917
*OPT?...........................................................................................................................917
*PCB............................................................................................................................ 917
*PRE............................................................................................................................ 917
*PSC............................................................................................................................ 917
*RST.............................................................................................................................918
*SRE............................................................................................................................ 918
*STB?...........................................................................................................................918
*TRG............................................................................................................................ 918
*TST?...........................................................................................................................918
*WAI.............................................................................................................................919
*CAL?
Calibration query
Initiates a calibration of the instrument and subsequently queries the calibration status.
Responses > 0 indicate errors.
Note: If you start a self-alignment remotely, then select the "Local" softkey while the
alignment is still running, the instrument only returns to the manual operation state
after the alignment is completed.
Usage:
Query only
Manual operation: See "Self Alignment" on page 511
Common Commands