R&S ESR Series

Spectrum Measurements
R&S
®
ESR
341User Manual 1175.7068.02 ─ 12
No. of Harmonics ← Harmonic Distortion
Sets the number of harmonics that shall be measured. The range is from 1 to 26.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:NHARmonics on page 788
Harmonic Sweep Time ← Harmonic Distortion
For details refer to the Sweeptime Manual softkey in the "Bandwidth" menu.
Harmonic RBW Auto ← Harmonic Distortion
Enables/disables the automatic adjustment of the resolution bandwidth for filter types
Normal (3dB) (Gaussian) and 5-Pole filters. The automatic adjustment is carried out
according to:
"RBW
n
= RBW
1
* n"
If RBW
n
is not available, the next higher value is used.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:BANDwidth:AUTO
on page 786
Adjust Settings ← Harmonic Distortion
Activates the frequency search in the frequency range that was set before starting the
harmonic measurement (if harmonic measurement was with span > 0) and adjusts the
level.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:PRESet on page 788
6.1.2 Measurement Configuration – MEAS CONFIG Key
The MEAS CONFIG key displays the submenu of the currently activated and running
measurement function, e.g. the submenu of "TOI" or "Harmonic Distortion" (see Chap-
ter 6.1.1, "Power Measurements – MEAS Key", on page 221, for quick access to the
measurement configuration. If no measurement function is activated, this key has no
effect.
6.1.3 Performing Measurements – RUN SINGLE/RUN CONT Keys
The [RUN SINGLE] and [RUN CONT] keys are used to start measurement tasks.
●
[RUN SINGLE] switches to single sweep mode and performs a single sweep, just
as the Single Sweep softkey in the "Sweep" menu does.
●
[RUN CONT] switches to continuous sweep mode and starts sweeping, just as the
Continuous Sweep softkey in the "Sweep" menu does.
Measurements