R&S ESR Series

Remote Control
R&S
®
ESR
820User Manual 1175.7068.02 ─ 12
<AVGPower> ON | OFF
Turns average power evaluation on and off.
*RST: OFF
<TriggerSource> IMMediate | EXTernal | VIDeo | IFPower | RFPower
Selects a trigger source.
For more information see "Trg/Gate Source" on page 375.
*RST: IMM
<TriggerSlope> NEGative | POSitive
Selects the trigger slope.
*RST: POS
<TriggerOffset> Defines the trigger delay. The trigger delay is the time between
the detection of the trigger signal and the start of the measure-
ment at the next frequency point.
Range: span = 0 Hz: (-sweep time) to 30 s; span > 10 Hz:
31.25 ns to 30 s
*RST: 0 s
<GateLength> Defines the gate length for gated measurements.
Setting 0 seconds turns gated measurements off. Other values
activate the gated trigger function.
To perform gated measurements, the trigger source must be dif-
ferent from IMMediate.
Range: 31.25 ns to 30 s
*RST: 0 s
Example:
SENSe:LIST:POWer:SET ON,OFF,OFF,EXT,POS,10US,
434US
[SENSe:]LIST:POWer:STATe <State>
This command turns the List Evaluation off.
Parameters:
<State> OFF
Example:
SENS:LIST:POW:STAT OFF
11.5.1.15 Probe Configuration
PROBe:ID:PARTnumber?............................................................................................... 821
PROBe:ID:SRNumber?.................................................................................................. 821
PROBe:SETup:MODE....................................................................................................821
PROBe:SETup:NAME?...................................................................................................821
PROBe:SETup:STATe?...................................................................................................821
PROBe[:STATe]............................................................................................................. 822
Remote Commands in Spectrum Analyzer Mode