Remote Control
R&S
®
ESR
687User Manual 1175.7068.02 ─ 12
FOURphase
R&S ESH2-Z5: four phases and protective earth are controlla-
ble.
OFF
Turns off remote control of the LISN.
TWOPhase
R&S ESH3-Z5: two phases and protective earth are controllable.
*RST: OFF
Example:
INP:LISN TWOP
Turns automatic control of the network on and selects the R&S
ESH3-Z5 network.
Manual operation: See "LISN Type" on page 197
See "LISN Control" on page 302
11.4.7
Working with Markers
● Configuring Marker Functionality.......................................................................... 687
● Using Markers.......................................................................................................691
● Using Delta Markers..............................................................................................697
11.4.7.1 Configuring Marker Functionality
CALCulate<n>:MARKer<m>:COUPled[:STATe].................................................................687
CALCulate<n>:MARKer<m>:FUNCtion:CENTer................................................................ 688
CALCulate<n>:MARKer<m>:FUNCtion:CSTep..................................................................688
CALCulate<n>:MARKer<m>:FUNCtion:ZOOM..................................................................688
CALCulate<n>:MARKer<m>:SCOupled[:STATe]................................................................689
CALCulate<n>:MARKer<m>:X:SLIMits:LEFT....................................................................689
CALCulate<n>:MARKer<m>:X:SLIMits:RIGHT..................................................................689
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe].................................................................690
DISPlay[:WINDow<n>]:MINFo:STATe...............................................................................690
CALCulate<n>:MARKer<m>:COUPled[:STATe] <State>
This command couples or decouples the receiver frequency to the current marker fre-
quency.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:MARK:COUP ON
Couples the frequency to the marker frequency.
Manual operation: See "Marker Track" on page 204
Remote Commands in Receiver Mode