R&S ESR Series User Manual

Receiver Mode
R&S
®
ESR
198User Manual 1175.7068.02 ─ 12
150 kHz Highpass Filter
Turns the highpass filter avaiable with the R&S ENV216 network on and off.
For more information see Chapter 5.2.5, "V-Networks Control (LISN)", on page 173.
Remote command:
Highpass filter for the scan:
INPut:LISN:FILTer:HPAS[:STATe] on page 685
Highpass filter for the final measurement:
[SENSe:]FMEasurement:LISN:FILTer:HPAS[:STATe] on page 684
5.4 Common Analysis Functions
5.4.1 Trace Configuration
The TRACE key is used to configure the data acquisition for measurement and the
analysis of the measurement data.
The R&S ESR is capable of displaying up to six different traces at a time in a diagram.
A trace consists of a maximum of 691 displayed measurement points on the horizontal
axis (frequency or time). If more measured values than measurement points are availa-
ble, several measured values are combined in one displayed measurement point.
The trace functions include the following:
●
Display mode of the trace
For details on trace modes see Chapter 5.2.3, "Trace Modes", on page 171.
●
Evaluation of individual measurement points of a trace. For details on detectors
see Chapter 5.2.2, "Detectors", on page 167.
To open the Trace menu
●
Press the TRACE key.
The "Trace" menu is displayed.
Further information
●
Chapter 5.2.3, "Trace Modes", on page 171
●
Chapter 5.2.2, "Detectors", on page 167
●
Chapter 6.3.1.6, "ASCII File Export Format", on page 399
Tasks
●
Chapter 6.3.1.2, "Configuring Traces", on page 395
●
Chapter 6.3.1.3, "Specifying the Trace Settings", on page 397
The following table shows all softkeys available in the "Trace" menu. It is possible that
your instrument configuration does not provide all softkeys. If a softkey is only available
Common Analysis Functions

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English