R&S ESR Series

Remote Control
R&S
®
ESR
975User Manual 1175.7068.02 ─ 12
Example:
HCOP:TREP:TEST:REM 2
Deletes the second dataset from the current test report.
Manual operation: See "Adding and Removing Datasets" on page 551
HCOPy:TREPort:TEST:REMove:SELected
This command deletes all selected datasets that are currently part of a test report.
Example:
HCOP:TREP:TEST:SEL:NONE
Deselects all datasets.
HCOP:TREP:TEST:SEL 2,ON
HCOP:TREP:TEST:SEL 3,ON
Selects the second and third datasets.
HCOP:TREP:TEST:REM:SEL
Deletes the selected datasets (the second and third).
Usage: Event
Manual operation: See "Adding and Removing Datasets" on page 551
11.13.2.3 Selecting Datasets for the Report
HCOPy:TREPort:TEST:SELect........................................................................................975
HCOPy:TREPort:TEST:SELect:ALL................................................................................. 975
HCOPy:TREPort:TEST:SELect:INVert..............................................................................976
HCOPy:TREPort:TEST:SELect:NONE..............................................................................976
HCOPy:TREPort:TEST:SELect <Dataset>, <State>
This command includes or excludes datasets from the test report.
Parameters:
<Dataset> Index number of the dataset as shown in the "Test Report Con-
tent Selection" dialog box.
If the index number is greater than the number of available data-
sets, the command does nothing.
<State> ON | OFF
Example:
HCOP:TREP:TEST:SEL 2, OFF
Excludes the second dataset from the test report.
Manual operation: See "Selecting Datasets for the Report" on page 551
HCOPy:TREPort:TEST:SELect:ALL
This command includes all available datasets in a test report.
Example:
HCOP:TREP:TEST:SEL:ALL
Includes all available datasets in the test report.
Usage: Event
Working with Test Reports