R&S ESR Series

Remote Control
R&S
®
ESR
927User Manual 1175.7068.02 ─ 12
SYSTem:ERRor:LIST?
This command reads all system messages and returns a list of comma separated
strings. Each string corresponds to an entry in the table SYSTEM MESSAGES.
If the error list is empty, an empty string " is returned.
This command is a query and therefore has no *RST value.
Example:
SYST:ERR:LIST?
Usage: Query only
Manual operation: See "System Messages" on page 524
SYSTem:ERRor[:NEXT]?
This command queries the earliest error queue entry and deletes it.
Positive error numbers indicate device-specific errors, negative error numbers are error
messages defined by SCPI. If the error queue is empty, the error number 0, "No error",
is returned.
This command is a query and therefore has no *RST value.
Example:
STAT:ERR?
Usage: Query only
SCPI confirmed
11.9.3 Coupling Parameters
INSTrument:COUPle:ATTen............................................................................................ 927
INSTrument:COUPle:BANDwidth.....................................................................................928
INSTrument:COUPle:CENTer..........................................................................................928
INSTrument:COUPle:DEMod.......................................................................................... 928
INSTrument:COUPle:GAIN............................................................................................. 929
INSTrument:COUPle:LIMit.............................................................................................. 929
INSTrument:COUPle:MARKer.........................................................................................929
INSTrument:COUPle:PRESel..........................................................................................930
INSTrument:COUPle:PROT............................................................................................ 930
INSTrument:COUPle:SPAN.............................................................................................930
INSTrument:COUPle:ATTen <State>
This command turns synchronization of the attenuation and unit between measure-
ment channels on and off.
Parameters:
<State> ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
System Configuration