R&S ESR Series

Receiver Mode
R&S
®
ESR
207User Manual 1175.7068.02 ─ 12
Remote command:
CALCulate<n>:THReshold:STATe on page 865
CALCulate<n>:THReshold on page 865
Use Zoom Limits ← Search Limits
Restricts the marker search to the zoomed area.
Note that the marker zoom is only available in Spectrum mode.
Remote command:
CALCulate<n>:MARKer<m>:X:SLIMits:ZOOM on page 864
Search Lim Off ← Search Limits
Deactivates all limits of the search range.
Remote command:
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe] on page 690
CALCulate<n>:THReshold:STATe on page 865
Peak Excursion
Opens an edit dialog box for level measurements to enter the minimum level value by
which a signal must rise or fall so that it will be identified as a maximum or a minimum
by the search functions. Entries from 0 dB to 80 dB are allowed; the resolution is 0.1
dB. The default setting for the peak excursion is 6 dB.
Remote command:
CALCulate<n>:MARKer<m>:PEXCursion on page 679
5.4.2.3 Markers in Spectrograms
In addition to the marker functionality described above, spectrograms support the fol-
lowing marker positioning functionality.
Search Mode...............................................................................................................207
└ Next Mode X................................................................................................. 207
└ Next Mode Y................................................................................................. 208
└ Marker Search Type......................................................................................208
└ Select Search Area.......................................................................................208
Search Mode
Opens a submenu to select the marker search mode.
Next Mode X ← Search Mode
Sets the search mode for the marker peak search if a search in the x-direction is
active. Three modes are available:
"<"
Sets the active marker/delta marker to the next maximum/minimum
left of the marker of the selected trace.
"abs"
Sets the active marker/delta marker to the next lower maximum/
higher minimum of the selected trace.
">"
Sets the active marker/delta marker to the next maximum/minimum
right of the marker of the selected trace.
Common Analysis Functions