R&S ESR Series User Manual

Remote Control
R&S
®
ESR
840User Manual 1175.7068.02 ─ 12
MASK
Selects the frequency mask trigger.
TDTRigger
Selects the time domain trigger.
TIME
Selects the time trigger.
VIDeo
Selects the video trigger. The video trigger is available for time
domain measurements.
*RST: IMMediate
Example:
TRIG:SOUR EXT
Selects the external trigger input as source of the trigger signal
Manual operation: See "External" on page 186
See "Free Run" on page 186
See "Video" on page 186
See "Trg/Gate Source" on page 375
See "Free Run" on page 375
See "External" on page 375
See "Video" on page 376
See "RF Power" on page 376
See "IF Power/BB Power" on page 376
See "Time" on page 377
TRIGger<n>[:SEQuence]:TIME:RINTerval <Interval>
This command sets the repetition interval for the time trigger source.
Suffix:
<n>
.
irrelevant
Parameters:
<Interval> 2.0 ms to 5000
*RST: 1.0
Example:
TRIG:SOUR TIME
Selects the time trigger input for triggering.
TRIG:TIME:RINT 50
The sweep starts every 50 s.
Mode: All
Manual operation: See "Repetition Interval" on page 378
Gated Measurements
[SENSe:]SWEep:EGATe................................................................................................. 841
[SENSe:]SWEep:EGATe:HOLDoff....................................................................................841
[SENSe:]SWEep:EGATe:LENGth.....................................................................................842
Remote Commands in Spectrum Analyzer Mode

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English