R&S ESR Series

Remote Control
R&S
®
ESR
793User Manual 1175.7068.02 ─ 12
CALCulate<n>:STATistics:NSAMples <NoMeasPoints>
This command sets the number of measurement points to be acquired for the statisti-
cal measurement functions.
Suffix:
<n>
.
irrelevant
Parameters:
<NoMeasPoints> 100 to 1E9
*RST: 100000
Example:
CALC:STAT:NSAM 500
Sets the number of measurement points to be acquired to 500.
Manual operation: See "# of Samples" on page 317
Retrieving Results
The following commands are required to retrieve the measurement results.
Commands useful to retrieve results described elsewhere:
●
CALCulate<n>:MARKer<m>:X on page 695
●
TRACe<n>:DATA on page 726
CALCulate<n>:STATistics:CCDF:X<Trace>...................................................................... 793
CALCulate<n>:STATistics:RESult<Trace>........................................................................ 794
CALCulate<n>:STATistics:CCDF:X<Trace> <Probability>
This command queries the results of the complementary cumulative distribution func-
tion (CCDF) for the specified probability (corresponding to the "Percent Marker" in the
display, see "Percent Marker" on page 322).The suffix of X defines the trace number.
Suffix:
<n>
.
irrelevant
<Trace> 1...6
trace
Parameters:
<Probability> P0_01: Level value for 0.01 % probability
P0_1: Level value for 0.1 % probability
P1: Level value for 1 % probability
P10: Level value for 10 % probability
Example:
CALC:STAT:CCDF:X1? P10
Returns the level values that are over 10 % above the mean
value.
Manual operation: See "CCDF" on page 321
Remote Commands in Spectrum Analyzer Mode