R&S ESR Series

Remote Control
R&S
®
ESR
973User Manual 1175.7068.02 ─ 12
Example:
HCOP:TREP:ITEM:TEMP:LOAD 'myTemplate'
Loads a test report template.
Usage: Event
HCOPy:TREPort:ITEM:TEMPlate:SAVE <Template>
This command saves a test report template.
Parameters:
<Template> String containing the name of the template.
Example:
HCOP:TREP:ITEM:TEMP:SAVE 'myTemplate'
Saves a test report template.
Usage: Event
11.13.2
Creating a Test Report
● Configuring and Printing the Test Report.............................................................. 973
● Adding and Removing Datasets............................................................................974
● Selecting Datasets for the Report......................................................................... 975
11.13.2.1 Configuring and Printing the Test Report
Commands useful to configure and print the test report described elsewhere:
●
HCOPy:DEVice:LANGuage<1|2> on page 961
●
HCOPy[:IMMediate<1|2>] on page 963
●
MMEMory:NAME on page 945
HCOPy:MODE...............................................................................................................973
HCOPy:MODE <Mode>
Selects the output of the HCOPy[:IMMediate<1|2>] command.
Parameters:
<Mode> SCReen
HCOPy:IMMediate prints the current screen contents.
REPort
HCOPy:IMMediate generates a measurement report.
*RST: SCReen
Example:
HCOP:MODE REPort
HCOP
Creates a file containing the measurement report.
Working with Test Reports