R&S ESR Series

Remote Control
R&S
®
ESR
991User Manual 1175.7068.02 ─ 12
11.15.2 Emulating HP Instruments
SYSTem:REVision:FACTory............................................................................................ 991
SYSTem:REVision[:STRing]............................................................................................991
SYSTem:RSW............................................................................................................... 992
SYSTem:LANGuage.......................................................................................................992
SYSTem:HPCoupling..................................................................................................... 992
SYSTem:IFGain:MODE.................................................................................................. 993
SYSTem:TWALking........................................................................................................993
SYSTem:REVision:FACTory
Resets the response to the REV? query to the default value, e.g. after a user string
was defined using the SYSTem:REVision[:STRing] command. (REV? query availa-
ble for HP emulation only, see Chapter 11.18, "GPIB Commands of HP Models 856xE,
8566A/B, 8568A/B and 8594E", on page 1039.)
Example:
Define the system language:
SYST:LANG '8563E'
Set the response back to factory setting:
SYS:REV:FACT
Query the revision:
REV?
Response:
920528
Usage: Event
SCPI confirmed
Manual operation: See "REV String Factory" on page 517
SYSTem:REVision[:STRing] <Name>
Sets the response to the REV? queryto the defined string (HP emulation only, see
Chapter 11.18, "GPIB Commands of HP Models 856xE, 8566A/B, 8568A/B and
8594E", on page 1039).
Parameters:
<Name>
Example: Define the system language:
SYST:LANG '8563E'
Query the revision:
REV?
Response:
920528
Set the response to 'NewRevision':
SYST:REV:STR 'NewRevision'
Query the response:
SYST:REV:STR?
Response:
NewRevision
Network Connection