R&S ESR Series User Manual

Receiver Mode
R&S
®
ESR
196User Manual 1175.7068.02 ─ 12
Final Measurement Time
Defines the measurement time for the final measurement.
The measurement time is the time during which the R&S ESR measures the input sig-
nal and forms a measurement result weighted by the selected detector. The measure-
ment time does not include settling times of the synthesizer and the IF filter. The
R&S ESR automatically waits until transients are over.
Interactive Mode
Turns interactive final measurements on and off.
Remote command:
[SENSe:]FMEasurement:AUTO on page 643
Trace 1 to 6
Selects the characteristics of each trace.
In addition to the trace mode, you can select a detector for the scan and the final mea-
surement. For more information see
●
Chapter 5.1.3, "Scans", on page 144
●
Chapter 5.1.5, "Final Measurement", on page 150
●
Chapter 5.2.3, "Trace Modes", on page 171
●
Chapter 5.2.2, "Detectors", on page 167
Note: When you select detector type "None" for the final measurement, the R&S ESR
ignores peaks found on the corresponding trace during the final measurement.
Remote command:
Trace mode:
DISPlay[:WINDow<n>]:TRACe<t>:MODE on page 683
Scan detector:
[SENSe:][WINDow:]DETector<trace>[:FUNCtion] on page 683
Final measurement detector:
[SENSe:]DETector<t>:FMEasurement on page 642
5.3.7.6 LISN Settings
The "LISN Settings" tab in the "Test Automation" dialog box contains functionality to
control line impedance networks.
Common Measurement Settings

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English