R&S ESR Series User Manual

Receiver Mode
R&S
®
ESR
197User Manual 1175.7068.02 ─ 12
LISN Type................................................................................................................... 197
Prescan Phase............................................................................................................197
Final Test Phase..........................................................................................................197
150 kHz Highpass Filter..............................................................................................198
LISN Type
Selects the V-network to be controlled via the user port.
For more information see Chapter 5.2.5, "V-Networks Control (LISN)", on page 173.
Remote command:
For the scan:
INPut:LISN[:TYPE] on page 686
For the final measurement:
[SENSe:]FMEasurement:LISN[:TYPE] on page 685
Prescan Phase
Selects the phase of the network you want to control during the scan.
During the scan, you can control more than one phase at a time.
For more information see Chapter 5.2.5, "V-Networks Control (LISN)", on page 173.
Remote command:
INPut:LISN:PHASe on page 686
Final Test Phase
Selects the phase of the network you want to control during the final measurement.
During the final measurement you can control more than one phase.
For more information see Chapter 5.2.5, "V-Networks Control (LISN)", on page 173.
Remote command:
[SENSe:]FMEasurement:LISN:PHASe on page 684
Common Measurement Settings

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English