R&S ESR Series

Remote Control
R&S
®
ESR
682User Manual 1175.7068.02 ─ 12
DISPlay[:WINDow<n>]:TRACe<t>:SYMBol <Symbol>
This command turns the peak labels in the diagram on and off.
Parameters:
<Symbol> CROSs
Each peak is labelled by a symbol. The symbol and its color
depend on the trace the peak is on.
OFF
Peak labels are off.
*RST: OFF
Example:
DISP:TRAC:SYMB CROS
Manual operation: See "Symbols (On Off)" on page 195
MMEMory:STORe:FINal
<FileName>
This command exports the contents of the final measurement peak list to a file in ASCII
format.
Parameters:
<FileName> String containg the file name. The extension of the file is *.dat.
Example:
:MMEM:STOR:FIN 'A:\TEST.DAT'
Usage: Event
Manual operation: See "Peak List Export" on page 195
MMEMory:STORe:PEAKlist <FileName>
This command exports the contents of a peak list to a file in ASCII format.
Parameters:
<FileName> String containg the file name. The extension of the file is *.dat.
Example:
MMEM:STOR:PEAK 'D:\TEST.DAT'
Manual operation: See "Peak List Export" on page 195
11.4.6.5 Trace Configuration
Commands useful to configure traces and final measurements described elsewhere:
●
[SENSe:]FMEasurement:AUTO on page 643
●
[SENSe:]FMEasurement:TIME on page 643
●
[SENSe:]DETector<t>:FMEasurement on page 642
[SENSe:][WINDow:]DETector<trace>[:FUNCtion].............................................................. 683
DISPlay[:WINDow<n>]:TRACe<t>:MODE.........................................................................683
Remote Commands in Receiver Mode