Remote Control
R&S
®
ESR
996User Manual 1175.7068.02 ─ 12
STATus:OPERation:CONDition?
STATus:QUEStionable:CONDition?
STATus:QUEStionable:ACPLimit:CONDition?
STATus:QUEStionable:FREQuency:CONDition?
STATus:QUEStionable:LIMit<n>:CONDition?
STATus:QUEStionable:LMARgin<n>:CONDition?
STATus:QUEStionable:POWer:CONDition?
STATus:QUEStionable:TRANsducer:CONDition?
These commands read out the CONDition section of the status register.
The commands do not delete the contents of the EVENt section.
Usage:
Query only
11.16.4 Controlling the ENABle Part
For more information on the enable part see Chapter 11.1.6.2, "Structure of a SCPI
Status Register", on page 575.
STATus:OPERation:ENABle <SumBit>
STATus:QUEStionable:ENABle <SumBit>
STATus:QUEStionable:ACPLimit:ENABle <SumBit>
STATus:QUEStionable:FREQuency:ENABle <SumBit>
STATus:QUEStionable:LIMit<n>:ENABle <SumBit>
STATus:QUEStionable:LMARgin<n>:ENABle <SumBit>
STATus:QUEStionable:POWer:ENABle <SumBit>
STATus:QUEStionable:TRANsducer:ENABle <SumBit>
These commands control the ENABle part of a register.
The ENABle part allows true conditions in the EVENt part of the status register to bere-
ported in the summary bit. If a bit is 1 in the enable register and its associated event bit
transitions to true, a positive transition will occur in the summary bit reported to the
next higher level.
Parameters:
<SumBit> Range: 0 to 65535
11.16.5 Controlling the Negative Transition Part
For more information on the positive transition part see Chapter 11.1.6.2, "Structure of
a SCPI Status Register", on page 575.
STATus:OPERation:NTRansition <SumBit>
STATus:QUEStionable:NTRansition <SumBit>
STATus:QUEStionable:ACPLimit:NTRansition <SumBit>
STATus:QUEStionable:FREQuency:NTRansition <SumBit>
STATus:QUEStionable:LIMit<n>:NTRansition <SumBit>
STATus:QUEStionable:LMARgin<n>:NTRansition <SumBit>
Status Register
To Next Page
Loading...
