R&S ESR Series

Remote Control
R&S
®
ESR
779User Manual 1175.7068.02 ─ 12
Remote commands exclusive to EMI measurements:
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:STATe........................................... 779
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:STATe <State>
This command turns the EMI measurement marker functionality on and off.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<State> ON | OFF
Performing a Peak Search
Commands useful to perform EMI measurements described elsewhere:
●
CALCulate<n>:DELTamarker<m>:AOFF on page 697
●
CALCulate<n>:DELTamarker<m>:TRACe on page 701
●
CALCulate<n>:MARKer<m>:AOFF on page 691
●
CALCulate<n>:MARKer<m>:TRACe on page 695
Remote commands exclusive to EMI measurements:
CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement:DETector................................779
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:DETector....................................... 780
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:DWELl.......................................... 780
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:PSEarch:AUTO..............................781
CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement:DETector <Detector>
This command selects the detector for a specific deltamarker during the final evalua-
tion.
If the deltamarker hasn't been active yet, the command also turns the deltamarker on.
Suffix:
<n>
.
irrelevant
<m> deltamarker
Parameters:
<Detector> OFF
turns the deltamarker off
AVER
average detector
CAV
CISPR Average detector
CRMS
RMS Average detector
Remote Commands in Spectrum Analyzer Mode