R&S ESR Series

Remote Control
R&S
®
ESR
781User Manual 1175.7068.02 ─ 12
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:PSEarch:AUTO
This command initiates a marker peak search.
Instead of the syntax element PSEarch you can also use PEAKsearch.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Usage: Event
Manual operation: See "Auto Peak Search" on page 303
See "Marker Configuration" on page 303
Evaluating the Results
CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement:LIMit<k>:CONDition ?............. 781
CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement:LIMit<k>:DELTa?.................... 782
CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement:RESult?................................. 782
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:LIMit<k>:CONDition ?.....................782
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:LIMit<k>:DELTa?............................783
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement:RESult?........................................ 783
CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement:LIMit<k>:
CONDition ? <Condition>
This command queries the condition of a deltamarker position in relation to a certain
limit line.
Suffix:
<n>
.
irrelevant
<m> 1...16
deltamarker
<k> 1...8
limit line
Return values:
<Condition> 0
The deltamarker has passed the limit check.
1
The deltamarker is inside the margins of a limit line.
2
The deltamarker has failed the limit check.
Example:
CALC:DELT2:FUNC:FME:LIM2:COND?
Queries the condition of deltamarker 2 in relation to limit line 2.
Usage: Query only
Manual operation: See "Marker Table" on page 305
Remote Commands in Spectrum Analyzer Mode