R&S ESR Series User Manual

Remote Control
R&S
®
ESR
719User Manual 1175.7068.02 ─ 12
Example:
CALC:LIM:STAT ON
Switches on the limit check for limit line 1.
Manual operation: See "Select Traces to check" on page 210
See "Deselect All" on page 210
11.5 Remote Commands in Spectrum Analyzer Mode
The following remote commands configure and perform spectrum measurements.
They are available in spectrum analyzer mode only.
● Measurements and Result Displays......................................................................719
● Configuring Spectrum Measurements...................................................................822
● Analyzing Spectrum Measurements..................................................................... 847
11.5.1 Measurements and Result Displays
● Controlling Power Measurements.........................................................................719
● Measuring Channel Power....................................................................................727
● Measuring the Occupied Bandwidth..................................................................... 748
● Measuring Spurious Emissions.............................................................................749
● Testing Against a Spectrum Emission Mask......................................................... 759
● Performing EMI Measurements............................................................................ 778
● Measuring the Modulation Depth.......................................................................... 784
● Measuring the Harmonic Distortion.......................................................................786
● Measuring the Carrier-to-Noise Ratio................................................................... 790
● Measuring the Third Order Intercept Point............................................................790
● Measuring Statistics..............................................................................................791
● Measuring in the Time Domain............................................................................. 799
● Measuring the Pulse Power.................................................................................. 811
● Performing List Evaluations.................................................................................. 815
● Probe Configuration.............................................................................................. 820
11.5.1.1 Controlling Power Measurements
The following commands control power measurements (channel power, occupied
bandwidth etc.) in general.
CALCulate<n>:MARKer<m>:FUNCtion:POWer:SELect..................................................... 720
CALCulate<n>:MARKer<m>:FUNCtion:POWer:RESult?....................................................721
CALCulate<n>:MARKer<m>:FUNCtion:POWer[:STATe].....................................................724
CALCulate<n>:MARKer<m>:FUNCtion:POWer:MODE...................................................... 724
[SENSe:]POWer:TRACe.................................................................................................725
[SENSe:]POWer:ACHannel:PRESet................................................................................ 725
[SENSe:]POWer:ACHannel:PRESet:RLEVel.....................................................................726
TRACe<n>:DATA...........................................................................................................726
Remote Commands in Spectrum Analyzer Mode

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English