R&S ESR Series

Remote Control
R&S
®
ESR
750User Manual 1175.7068.02 ─ 12
MMEMory:STORe<n>:SPURious <FileName>
This command exports the marker peak list available for spurious emission measure-
ments to a file.
Suffix:
<n>
.
irrelevant
Parameters:
<FileName> String containing the path and name of the target file.
Example:
MMEM:STOR:SPUR 'test'
Saves the current marker peak list in the file test.dat.
Usage: Event
Managing a Sweep List
The following commands configure the sweep list for spurious emission measure-
ments.
[SENSe:]LIST:RANGe<range>:BANDwidth[:RESolution]....................................................750
[SENSe:]LIST:RANGe<range>:BANDwidth:VIDeo.............................................................751
[SENSe:]LIST:RANGe<range>:BREak............................................................................. 751
[SENSe:]LIST:RANGe<range>:COUNt.............................................................................751
[SENSe:]LIST:RANGe<range>:DELete.............................................................................752
[SENSe:]LIST:RANGe<range>:DETector.......................................................................... 752
[SENSe:]LIST:RANGe<range>:FILTer:TYPE..................................................................... 752
[SENSe:]LIST:RANGe<range>[:FREQuency]:STARt..........................................................753
[SENSe:]LIST:RANGe<range>[:FREQuency]:STOP.......................................................... 753
[SENSe:]LIST:RANGe<range>:INPut:ATTenuation............................................................ 754
[SENSe:]LIST:RANGe<range>:INPut:ATTenuation:AUTO...................................................754
[SENSe:]LIST:RANGe<range>:INPut:GAIN:STATe............................................................ 754
[SENSe:]LIST:RANGe<range>:LIMit:STARt...................................................................... 755
[SENSe:]LIST:RANGe<range>:LIMit:STATe...................................................................... 755
[SENSe:]LIST:RANGe<range>:LIMit:STOP.......................................................................756
[SENSe:]LIST:RANGe<range>:POINts.............................................................................756
[SENSe:]LIST:RANGe<range>:RLEVel.............................................................................756
[SENSe:]LIST:RANGe<range>:SWEep:TIME....................................................................757
[SENSe:]LIST:RANGe<range>:SWEep:TIME:AUTO..........................................................757
[SENSe:]LIST:RANGe<range>:TRANsducer.....................................................................757
[SENSe:]LIST:RANGe<range>:BANDwidth[:RESolution] <Value>
This command sets the RBW value for the specified range.
Suffix:
<range>
.
1...20
range
Parameters:
<Value> Refer to the data sheet.
*RST: 30.0 kHz
Remote Commands in Spectrum Analyzer Mode