R&S ESR Series

Remote Control
R&S
®
ESR
752User Manual 1175.7068.02 ─ 12
Example:
LIST:RANG:COUNt?
Returns the number of defined ranges.
[SENSe:]LIST:RANGe<range>:DELete
This command deletes the specified range. The range numbers are updated accord-
ingly. The reference range cannot be deleted. A minimum of three ranges is manda-
tory.
Suffix:
<range>
.
1...20
range
Example:
LIST:RANG4:DEL
Deletes range 4.
Manual operation: See "Delete Range" on page 292
[SENSe:]LIST:RANGe<range>:DETector
<Detector>
This command sets the detector for the specified range. For details refer to "Detector"
on page 290.
Suffix:
<range>
.
1...20
range
Parameters:
<Detector> NEGative | POSitive | SAMPle | RMS | AVERage
NEGative
minimum peak detector
POSitive
peak detector
SAMPle
sample detector
RMS
RMS detector
AVERage
average detector
*RST:
RMS
Example:
LIST:RANGe3:DET SAMP
Sets the sample detector for range 3.
Manual operation: See "Detector" on page 290
[SENSe:]LIST:RANGe<range>:FILTer:TYPE <Type>
This command sets the filter type for the specified range.
Remote Commands in Spectrum Analyzer Mode