R&S ESR Series

Remote Control
R&S
®
ESR
691User Manual 1175.7068.02 ─ 12
Parameters:
<State> ON | OFF
*RST: ON
Example:
DISP:MINF:STAT ON
Turns the marker info field on.
Manual operation: See "Marker Info (On Off)" on page 203
11.4.7.2 Using Markers
CALCulate<n>:MARKer<m>:AOFF..................................................................................691
CALCulate<n>:MARKer<m>:MAXimum:LEFT...................................................................691
CALCulate<n>:MARKer<m>:MAXimum:NEXT..................................................................692
CALCulate<n>:MARKer<m>:MAXimum[:PEAK]................................................................ 692
CALCulate<n>:MARKer<m>:MAXimum:RIGHt..................................................................693
CALCulate<n>:MARKer<m>:MINimum:LEFT....................................................................693
CALCulate<n>:MARKer<m>:MINimum:NEXT................................................................... 693
CALCulate<n>:MARKer<m>:MINimum[:PEAK]................................................................. 694
CALCulate<n>:MARKer<m>:MINimum:RIGHt...................................................................694
CALCulate<n>:MARKer<m>[:STATe]............................................................................... 695
CALCulate<n>:MARKer<m>:TRACe................................................................................695
CALCulate<n>:MARKer<m>:X........................................................................................ 695
CALCulate<n>:MARKer<m>:Y........................................................................................ 696
CALCulate<n>:MARKer<m>:AOFF
This command all markers off, including delta markers and marker measurement func-
tions.
Suffix:
<n>
.
Selects the measurement window.
<m> depends on mode
irrelevant
Example:
CALC:MARK:AOFF
Switches off all markers.
Usage: Event
Manual operation: See "All Marker Off" on page 203
See "Marker Configuration" on page 303
CALCulate<n>:MARKer<m>:MAXimum:LEFT
This command positions a marker to the next smaller trace maximum on the left of the
current position (i.e. in descending X values).
If no next smaller maximum value is found on the trace (level spacing to adjacent val-
ues < peak excursion), an execution error (error code: -200) is produced.
Remote Commands in Receiver Mode