R&S ESR Series User Manual

Remote Control
R&S
®
ESR
692User Manual 1175.7068.02 ─ 12
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example:
CALC:MARK2:MAX:LEFT
Positions marker 2 to the next lower maximum value to the left
of the current value.
Usage: Event
Manual operation: See "Next Mode" on page 205
CALCulate<n>:MARKer<m>:MAXimum:NEXT
This command positions the marker to the next smaller trace maximum.
If no next smaller maximum value is found on the trace (level spacing to adjacent val-
ues < peak excursion), an execution error (error code: -200) is produced.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example:
CALC:MARK2:MAX:NEXT
Positions marker 2 to the next lower maximum value.
Usage: Event
Manual operation: See "Next Peak" on page 205
See "Next Mode" on page 205
CALCulate<n>:MARKer<m>:MAXimum[:PEAK]
This command positions the marker on the current trace maximum.
The corresponding marker is activated first or switched to the marker mode.
If no maximum value is found on the trace (level spacing to adjacent values < peak
excursion), an execution error (error code: -200) is produced.
Suffix:
<n>
.
Selects the measurement window.
<m> depends on mode
Selects the marker.
Example:
CALC:MARK2:MAX
Positions marker 2 to the maximum value of the trace.
Usage: Event
Manual operation: See "Peak" on page 205
Remote Commands in Receiver Mode

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English