R&S ESR Series

Spectrum Measurements
R&S
®
ESR
387User Manual 1175.7068.02 ─ 12
State
Activates a connected probe. Use this command to switch off the probe and measure
the digital input without considering the transducer factor of the probe.
Remote command:
PROBe[:STATe] on page 822
Name
Indicates the name of the connected probe.
Remote command:
PROBe:SETup:NAME? on page 821
Serial Number
Indicates the serial number of the connected probe.
Remote command:
PROBe:ID:SRNumber? on page 821
Part number
Indicates the material part number of the connected probe.
Remote command:
PROBe:ID:PARTnumber? on page 821
Micro Button Action
Defines which action is taken when the probe's micro button is pressed.
"RunSingle"
A single sweep is performed.
"No Action"
No action is taken.
Remote command:
PROBe:SETup:MODE on page 821
6.3 Analysis
General methods and basic settings to display and analyze measurements. If you are
performing a specific measurement task or using an operating mode other than Spec-
trum mode, be sure to check the specific measurement or mode description for set-
tings and functions that may deviate from these general ones.
● Trace Configuration...............................................................................................387
● Spectrogram..........................................................................................................402
● Markers................................................................................................................. 406
● Lines......................................................................................................................429
6.3.1 Trace Configuration
The TRACE key is used to configure the data acquisition for measurement and the
analysis of the measurement data.
Analysis