R&S ESR Series

Receiver Mode
R&S
®
ESR
205User Manual 1175.7068.02 ─ 12
●
"Specifying the Search Limits" on page 413
●
"Specifying the Search Range" on page 413
●
"Examining a Signal at the Center in Detail" on page 413
●
"Specifying the Suitable Peak Excursion" on page 414
Select Marker (No)
Opens a submenu to select one of 16 markers and define whether the marker is a nor-
mal or a delta marker (see "Marker 1 / Marker 2 / Marker 3 / … Marker 16,/ Marker
Norm/Delta" on page 201). "(No)" indicates the number of the currently active marker.
Peak
Sets the active marker/delta marker to the highest maximum of the trace.
Remote command:
CALCulate<n>:MARKer<m>:MAXimum[:PEAK] on page 692
CALCulate<n>:DELTamarker<m>:MAXimum[:PEAK] on page 699
Next Peak
Sets the active marker/delta marker to the next maximum of the selected trace.
Remote command:
CALCulate<n>:MARKer<m>:MAXimum:NEXT on page 692
CALCulate<n>:DELTamarker<m>:MAXimum:NEXT on page 698
Min
Sets the active marker/delta marker to the minimum of the selected trace.
Remote command:
CALCulate<n>:MARKer<m>:MINimum[:PEAK] on page 694
CALCulate<n>:DELTamarker<m>:MINimum[:PEAK] on page 700
Next Min
Sets the active marker/delta marker to the next minimum of the selected trace.
Remote command:
CALCulate<n>:MARKer<m>:MINimum:NEXT on page 693
CALCulate<n>:DELTamarker<m>:MINimum:NEXT on page 700
Next Mode
Selects the mode of the Next Peak or Next Min softkey.
Three settings are available:
"<"
Sets the active marker/delta marker to the next maximum/minimum
left to the marker of the selected trace.
"abs"
Sets the active marker/delta marker to the next lower maximum/
higher minimum of the selected trace.
">"
Sets the active marker/delta marker to the next maximum/minimum
right to the marker of the selected trace.
Common Analysis Functions