Instrument Function
R&S
®
SMBV100A
364Operating Manual 1176.8016.02 ─ 17
Data List Editor
The "Data List Editor" for editing the selected data list is called up in the "List Manage-
ment" submenu of the "Custom Digital Modulation" main menu by means of the "Edit
Data List..." button.
See Chapter 4.5, "Editors", on page 97 for description on how to use the editor.
Data List Editor
A list of binary values with a maximum length of 2^31 bits can be entered in the "Data
List Editor". This value corresponds to a file size of approx. 268 Mbyte.
To increase readability, the bits are displayed in groups of four. The current cursor
position, the length of the list and the list file name are displayed above the list. The
offset starts with the value 0 which corresponds to the bit position on the left side of the
first row, i.e. the beginning of the list. On the left edge of the editor, the last three offset
positions are specified at the beginning of the row.
An existing list can be edited in the insert or overwrite mode.
Remote command:
[:SOURce<hw>]:BB:DM:DLISt:SELect on page 681
[:SOURce<hw>]:BB:DM:DLISt:DATA on page 679
[:SOURce<hw>]:BB:DM:DLISt:DATA:APPend on page 680
GoTo ← Data List Editor
Opens the entry window for the bit position. The cursor marks the bit at the selected
position.
Remote command:
n.a.
Start Select ← Data List Editor
Defines the current cursor position as the start position for the range to be marked. The
stop position is defined by entering an offset under "GoTo".
When a start position has been activated, the button will be re-labelled to "Undo
Select". When the button is clicked now, the selected range will be deactivated.
Remote command:
n.a.
Copy ← Data List Editor
Copies the selected values.
Baseband Signal - Baseband Block
To Next Page
Loading...
