Ops 6–12 • Wipes, Patterns, Washes, and Mattes Vision Operator’s Manual (v12.0 MD)
4. Create a Video wash as follows:
•Use the Type knob on the Modify Wash Menu to select Video.
Video Wash — Modify Wash Menu
Operating Tip — Press Default Colors on the Modify Wash Menu to go back to the
original, default colors. The color selections for the MLE and Wash will be set back to default.
•Use the Video Bus knob on the Modify Wash Menu to select the crosspoint bus
you want to use to select the video source from. You can choose between the
following:
› Key X — Select this option to use the video source currently selected for
Keyer X as the video wash, where X is the number of the keyer.
› Program — Select this option to use the video source currently selected on
the Program Bus of the MLE as the video wash.
› Preset — Select this option to use the video source currently selected on the
Preset Bus of the MLE as the video wash.
› Utility 1 — Select this option to use the video source currently selected on the
Utility Bus as the video wash. The Utility Bus for the MLE is automatically
selected. Refer to the section “Selecting a Key or Utility Bus” on page Ops
4-8 for more information on selecting a Utility Bus.
› Utility 2 — Select this option to use the video source currently selected on the
Utility Bus as the video wash. The Utility Bus for the MLE is automatically
selected. Refer to the section “Selecting a Key or Utility Bus” on page Ops
4-8 for more information on selecting a Utility Bus.
•Use the Fill Type knob on the Modify Wash Menu to select how the video wash
will be displayed. You can choose between the following:
› ColorWash — Select this option to apply a gradient color wash to the
selected video signal. Proceed to Step (7.) to apply the color wash effect.
› Video — Select this option to apply an unaltered video signal with no color
effects applied. Proceed to Step (8.) to complete the procedure.
5. Create a Noise wash as follows:
•Use the Type knob on the Modify Wash Menu to select Noise.
• Proceed to Step (8.) to complete the procedure.
6. Create a SuperBlack wash as follows:
•Use the Type knob on the Modify Wash Menu to select SuperBlack.
• Proceed to Step (8.) to complete the procedure.
To Next Page
Loading...
