Vision Operator’s Manual (v12.0 MD) Memory Functions • Ops 8–11
5. Select the Global-Store or MLE-Store selections that you want to be recalled with the
memory as follows:
Note — The Recall Global-Store and Recall MLE-Store options must be set to Attributes in
order to be able to toggle them on or off from the MLE Memory Attributes Setup Menu. Refer
to the section “Personality List” on page Eng 11-2 for information on setting these options.
• Global-Store — Toggle a channel on to have the stills or animations selected for
that channel recalled with the memory. The default is off for all channels.
• MLE-Store — Toggle a channel on to have the stills or animations selected for that
channel recalled with the memory. The default is on for all channels.
Note — If the still or animation you want to recall in a Global-Store or MLE-Store channel
requires an alpha, you must also toggle the associated alpha channel on to have both the video
and alpha of the still or animation recalled with the memory.
6. Select the keyer on-air status that you want to be recalled with the memory as follows:
• Key X On/Off — Toggle a keyer on to have the on-air status of the keyer recalled
with the memory. Keyer parameters such as key type, clip, and gain settings are
always recalled with a memory. The default is on.
7. Insert an auto transition after the memory recall as follows:
• Toggle Run Auto Trans on the MLE Memory Attributes Setup Menu on to
have an auto transition performed after a memory is recalled. Remember to set up
the transition in the Transition Module when you store the memory so that the
desired transition is performed after the memory is recalled. The default is off.
Operating Tip — Press Default Attributes on the MLE Memory Attributes Setup Menu to
return the attributes for the selected MLE to the default settings. When the attributes are not at
the default settings, the ATTRIB button on the MLE Memory Module lights.
8. Select the Transition Module components that you want to be recalled with the memory
as follows:
• Toggle Next Trans Buttons on the MLE Memory Attributes Setup Menu on to
have the selection of the Next Transition Select buttons recalled with the memory.
The default is on.
• Toggle Transition Area on the MLE Memory Attributes Setup Menu on to
have the Transition Parameter and Transition Type buttons, but not the Fader,
Transition or Next Transition Select buttons, recalled with the memory. The default
is on.
9. Press AuxBus on the MLE Memory Attributes Setup Menu.
To Next Page
Loading...
