Ops 8–12 • Memory Functions Vision Operator’s Manual (v12.0 MD)
Aux Bus — MLE Memory Attributes Setup Menu
10. Toggle a BnkXAuxY button on the MLE Memory Attributes Setup Menu on to have
the source selected on that Aux Bus recalled with the memory, where X is the number of
the bank and Y the number of the aux. The default is off for all Aux Buses.
11. Press Custom Control on the MLE Memory Attributes Setup Menu.
Custom Control — MLE Memory Attributes Setup Menu
12. Set a custom control to be run after a memory recall as follows:
•Use the Bank knob on the MLE Memory Attributes Setup Menu to select the
custom control bank that the custom control you want to run after a memory recall
is in.
•Use the Macro knob on the MLE Memory Attributes Setup Menu to select the
custom control that you want to run after a memory recall.
• Toggle Auto Run Custom Control on the MLE Memory Attributes Setup
Menu on to have the selected custom control run after a memory recall is performed
on the selected MLE. The default is off.
This completes the procedure for setting the MLE Attributes. To apply these settings to a memory
you must set the MLE Memory Attributes and then save the memory. If the MLE Memory
Attributes for a memory have not been set, or the memory was stored on an older software
version, the default MLE Memory Attributes settings are used.
To Next Page
Loading...
