Ops 9–10 • Still-Store Vision Operator’s Manual (v12.0 MD)
Animation Properties Menu
• Toggle Looping on the Animation Properties Menu to set whether the animation
will start over when it reaches the last frame of the animation.
• Toggle Reverse on the Animation Properties Menu to set whether the animation
plays forward or in reverse.
• Toggle AutoPlay on the Animation Properties Menu to set whether the
animation automatically starts to play when it is taken on-air.
• Toggle Display Frame on the Animation Properties Menu to On to enable this
feature. This feature is only available for Global-Store channels.
›Use the Displayed knob on the Animation Properties Menu to display a
specific, single frame, from the animation. The animation stops and only the
selected frame is displayed.
› Press Create Thumbnail on the Animation Properties Menu to create a
thumbnail from the selected frame. This thumbnail is used for the animation
on the Still-Store menus.
• Toggle Play Speed on the Animation Properties Menu to On to enable this
feature. This feature is only available for Global-Store channels.
›Use the Speed knob on the Animation Properties Menu to select the speed
that you want the animation to play out at.
• Toggle Trim on the Still-Store Animation Properties Menu to On to enable this
feature. This feature is only available for Global-Store channels.
›Use the Start Frame knob on the Animation Properties Menu to select the
frame that you want the animation to start at.
›Use the End Frame knob on the Animation Properties Menu to select the
frame that you want the animation to end at.
This completes the procedure for adjusting the on-air properties of a still.
For More Information...
• on shaped and unshaped auto keys, refer to the section “Assigning Input Types” on
page Eng 7-4.
To Next Page
Loading...
