Vision Operator’s Manual (v12.0 MD) WARP Effects • Ops 17–5
5. Adjust the lighting parameters of the effect as follows:
• Press Light on the S&T WARP Menu.
Film (Light) — S&T WARP Menu
•Use the Flash knob on the S&T WARP Menu, or the positioner, to select the
number of times the lighting effect flashes.
•Use the Intensity knob on the S&T WARP Menu, or the positioner, to select the
intensity of the light used in the lighting effect.
•Use the Radius knob on the S&T WARP Menu, or the positioner, to select the
radius of the lighting effect.
6. Adjust the color parameters of the effect as follows:
• Press Color on the S&T WARP Menu.
Film (Color) — S&T WARP Menu
•Use the Luminance knob on the S&T WARP Menu, or the positioner, to adjust
the luminance of the film effect.
•Use the Saturation knob on the S&T WARP Menu, or the positioner, to adjust the
saturation of the film effect.
•Use the Hue knob on the S&T WARP Menu, or the positioner, to adjust the hue of
the film effect.
To Next Page
Loading...
