Vision Operator’s Manual (v12.0 MD) WARP Effects • Ops 17–9
7. Adjust the position of the light source as follows:
• Press Light Pos. on the S&T WARP Menu.
Globe (Light Position) — S&T WARP Menu
•Use the Gleam Size knob on the S&T WARP Menu, or the positioner, to adjust
the size of the gleam on the globe produced by the light source.
•Use the Z Rot. knob on the S&T WARP Menu, or the positioner, to rotate the light
source around the globe in the Z-Axis.
•Use the X-Y Rot. knob on the S&T WARP Menu, or the positioner, to rotate the
light source around the globe in the X and Y-Axes.
This completes the procedure for setting up a Globe WARP.
To Next Page
Loading...
