SATO CL4NX Plus - Page 328

[Network]
328
A specialized application is required to scan the QR code.
The setting items are as follows:
Type
Select the timing to perform the periodic notification or disable this function.
Counter
You can select the counter for the print head, cutter, or both for the timing to perform the periodic
notification.
◦ Appears only if you have selected [Counter] in the [Type] menu.
Head
You can specify or check the print distance of the print head for the timing to perform the periodic
notification.
◦ Appears only if you have set [Counter] with [Head] or [Head+Cutter] in the [Type] menu.
Cutter
You can specify or check the number of cut times of the cutter for the timing to perform the
periodic notification.
◦ Appears only if you have set [Counter] with [Cutter] or [Head+Cutter] in the [Type] menu.
Notifications
Specifies the number of periodic notifications to be sent per day.
◦ Appears only if you have enabled the NTP function or installed the optional RTC kit, and if you
have selected [Daily] in the [Type] menu.
Weekday
Specifies the day of the week to perform the periodic notification.
◦ Appears only if you have enabled the NTP function or installed the optional RTC kit, and if you
have selected [Weekly] in the [Type] menu.
Day
Sets the date to perform the periodic notification.
◦ Appears only if you have enabled the NTP function or installed the optional RTC kit, and if you
have selected [Monthly] in the [Type] menu.
Time 1
Specifies the time to perform the first periodic notification.
◦ Appears only if you have enabled the NTP function or installed the optional RTC kit, and if you
have selected [Daily] in the [Type] menu.
Time 2
Specifies the time to perform the second periodic notification.