Engineering via SICAM WEB
SICAM RTUs, User Manual SICAM CMIC 177
DC8-001-2.09, Edition 08.2016
Category Parameter Meaning
MV_CASDU1 Address of the datapoint. The complete ad-
dress consists of CASDU1, CASDU2, IOA1,
IOA2 and IOA3. CASDU1 and CASDU2 =
255 means no spontaneous transmission.
MV_CASDU2 Address of the datapoint. The complete ad-
dress consists of CASDU1, CASDU2, IOA1,
IOA2 and IOA3. CASDU1 and CASDU2 =
255 means no spontaneous transmission.
MV_IOA1 Address of the datapoint. The complete ad-
dress consists of CASDU1, CASDU2, IOA1,
IOA2 and IOA3. CASDU1 and CASDU2 =
255 means no spontaneous transmission.
MV_IOA2 Address of the datapoint. The complete ad-
dress consists of CASDU1, CASDU2, IOA1,
IOA2 and IOA3. CASDU1 and CASDU2 =
255 means no spontaneous transmission.
MV_IOA3 Address of the datapoint. The complete ad-
dress consists of CASDU1, CASDU2, IOA1,
IOA2 and IOA3. CASDU1 and CASDU2 =
255 means no spontaneous transmission.
MV_TI Type identification according to
IEC 60870-5-101/104
Process control pc_Event The data point is displayed in the event list
pc_Process_Text The data point is displayed with this name
(max. 13 characters)
pc_State_TextOn The state ON for single or double point infor-
mation is displayed with this name (max.
6 characters)
pc_State_TextOff The state OFF for single or double point in-
formation is displayed with this name (max.
6 characters)
pc_State_TextFlt The state faulty position for double point in-
formation is displayed with this name (max.
6 characters)
pc_State_TextInt The state intermediate position for double
point information is displayed with this name
(max. 6 characters)
QID-BSE Source identification basic system element
QID-ST Source identification station number if mul-
tipoint traffic mode 0…99 if R-SID 0…254. If
automatic then the source ID will be learned.
QID-SSE Source identification supplementary system
element
Process value analog QID-BSE Source identification basic system element
QID-ST Source identification station number if mul-
tipoint traffic mode 0…99 if R-SID 0…254. If
automatic then the source ID will be learned.
QID-SSE Source identification supplementary system
element
pva_Process_Text The data point is displayed with this name
(max. 13 characters)
pva_Process_GroupNbr The data point is displayed in the cockpit in
this group (1…32)
pva_Process_GroupPos The data point is displayed in the cockpit on
this position (1…256)
pva_X_0% Value adaptation: Lower limit of the used
measuring range in the external (protocol
specific) format. The corresponding internal
value is defined at Y_0%.
To Next Page
Loading...
