Siemens SICAM CMIC - Page 198

Engineering via SICAM WEB
198 SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016
Processing type Parameter Meaning
RS_Image_TI Type identifier of corresponding return state
information (S)
• Single-point information
• D.-point information
Term_with_Conf Sending of termination immediately after
sending of confirmation (S)
NO/YES
Output_t_0 Command output time in seconds (S).
Attention: The time comes into effect only, if in
the message is not defined any time.
0.01 to 327.67
termination_t_0 Time between confirmation and termination (s)
0 = no termination
0 to 6553.5
RS_react_t_0 Information reaction time (S)
Pulse command: 0 .. time appropriate to out-
put time
Persistent command: 0 .. time appropriate to
termination time
0 to 6553.5
Output_t_1 Command output time in seconds (S).
Attention: The time comes into effect only, if in
the message is not defined any time.
0.01 to 327.67
termination_t_1 Time between confirmation and termination (s)
0 = no termination
0 to 6553.5
RS_react_t_1 Information reaction time (S)
Pulse command: 0 .. time appropriate to out-
put time
Persistent command: 0 .. time appropriate to
termination time
0 to 6553.5
DO_SC_1,5POL – single
command output 1,5-pole
Retry_suppression_T Command retry suppression time in seconds.
Within this time a command with same ad-
dress is discarded without error information (s)
0.1 to 6553.5
Output_t Command output time in seconds (S).
Attention: The time comes into effect only, if in
the message is not defined any time.
0.01 to 327.67
select_execute_t Max. time between select and execute (in se-
conds). After this time a recent select com-
mand is necessary.
0 = no select command is expected (direct
command transmission)
0.1 to 102.3
Sync_t Within this time (in sec) the interlock enabling
must occur on the command.
0 = no syncronisation over interlocking
0.1 to 6553.5
RS_Mon_t Return state information monitoring time in
seconds (S).
0 = no return state information monitoring
0.01 to 655.35
Command_prolong_t Command prolongation time in seconds (S)
0.01 to 327.67