Spectra T950 - Configure Routine Maintenance

Chapter 4 — Configuring the Library Configuring Optional Library Settings
November 2016 User Guide—Spectra T950 Library
125
Configure Routine Maintenance
Overview TheRoutineMaintenanceoptionconfiguresthelibraryto
automaticallyreset(reboot)theLCMonceaweek.Usingthisoptionisnot
requiredaspartofnormallibraryoperationandshouldbeleftdisabled.
YoumaybeaskedtoenablethisbySpectraLogicTechnicalSupportinthe
courseoftroubleshootingor
problemresolution.
Enable the Routine Maintenance Option UsethefollowingstepsifSpectra
LogicTechnicalSupportinstructsyoutoenabletheRoutineMaintenance
option.
1. AccesstheSystemSetupscreen(seeAccessingtheSystemSetupScreen
onpage104).
2. ClickEditnexttoRoutine MaintenanceintheOtherSettingspane.The
RoutineMaintenanceConfigurationscreendisplays.
3. SelectEnabletoenabletheRoutineMaintenanceoption.
4. UsetheDay of Week,Hour,andMinutedrop‐downliststoselectwhen
youwanttheautomaticreboottooccur.
Note: Whenthelibraryautomaticallyresets,alldatastorage
operationscurrentlyinprogressfail.SpectraLogicrecommends
thatyouselectatimewhenyouarenotperformingdatastorage
operations.
5. ClickSavetofinish.ClickPrevious toreturntotheSystemSetupscreen.
Important
Do not enable this option unless specifically instructed to do so by Spectra Logic
Technical Support.
Figure 67 The Routine Maintenance Configuration screen.