Spectra T950 - Configure How Storage Capacity Displays

Chapter 9 — Configuring and Using Media Lifecycle Management Enabling MLM and Configuring Global
November 2016 User Guide—Spectra T950 Library
291
Configure How Storage Capacity Displays
Bydefault,theGeneralStatusscreenshowstherawstoragecapacityforall
MLM‐enabledcartridgesintheselectedpartition.Ifdesired,youcan
configurethelibrarytouseabroadcast‐centricmethodfordisplayingthe
storagecapacityintermsofhoursofcontentusedandtotalhoursof
contentavailable.
1. Logintothelibraryasauserwithsuperuseroradministrator
privileges.
2. Fromthetoolbarmenu,selectConfiguration > Media Lifecycle
Management.TheMediaLifecycleManagementSettingsscreen
displays(seeFigure173onpage288).
3. SelectthemethodforconvertingtobroadcastcapacityfromtheConvert
to Broadcast Hoursdrop‐downlist.
Note: Toreturntodisplayingrawcapacity,selectNone.
Important
If you select None in the Convert to Broadcast Hours field, leave the Override
Broadcast Bit Rate value set to
0.
Figure 174 Select the conversion settings on the Convert to
Broadcast Hours drop-down list.