Spectra T950 - Reset a RIM or F-QIP; Hardware Reset

Chapter 12 — Library Troubleshooting Resetting Components
November 2016 User Guide—Spectra T950 Library
370
Reset a RIM or F-QIP
TheresetproceduresforaRIMandanF‐QIPareidentical.
Hardware Reset
ToperformahardwareresetofaRIMorF‐QIP,insertthetipofatoothpick
orothersimilarnon‐conductiveobjectintotheholeinthebackpanelto
presstheResetbutton.
BlueScale Software Reset
YoucanalsoresettheRIMorF‐QIPthroughtheBlueScaleuserinterface.
1. DeterminetheBlueScaleidentifierforthecontrolleryouneedtoreset.
Note: RIMsareshownasF‐QIPsintheBlueScaleuserinterfaceandare
identifiedaccordingtotheirphysicallocationinthelibrary.See
RIMandF‐QIPIdentifiersonpage65forinformationabout
identifiers.
2. Logintothelibraryasauserwithsuperuseroradministrator
privileges.
3. Fromthetoolbarmenu,selectMaintenance > Tools.TheMaintenance
Toolsscreendisplays.
4. SelectUtilities.TheUtilitiesscreendisplays.
Caution
Do not use a metallic object to press the reset button. You may inadvertently cause
an electrical short inside the module.
Figure 231 Location of the RIM or F-QIP hardware reset button.
Reset
RIM
Reset
F-QIP
Reset
RIM2