Spectra T950 - Configure the Bluescale Vision Camera - Black

Chapter 12 — Library Troubleshooting Discovering and Setting the BlueScale Vision Camera IP Address
November 2016 User Guide—Spectra T950 Library
378
14. Whenyoufinishconfiguringthecamera,clickExit toclosethewizard.
15. Ifdesired,re‐enablethecameraiconintheBlueScaleuserinterface
statusbar.
a. Fromthelibrary’suserinterface,selectConfiguration > System.The
SystemSetupscreendisplays.
b. ScrolldownuntilyouseetheOtherSettingspane(seeFigure57on
page105).
c. Enterthecamera’supdatedIPaddressintheBlueScale Vision IP
Addressfield.
d. ClickSave.Thepresenceofacameraicononthestatusbarindicates
thattheIPaddressisconfigured.
Configure the BlueScale Vision Camera - Black
1. Downloadthecamerasoftwarefromthesupportportalat:
Vivotek_InstallWizard‐v1.1.0.27.exe.
Note: TheVivotekFD8361FixedDomeNetworkCameraUser’sManual
saysthatthesoftwareislocatedonaCDshippedwiththe
camera.TheCDisnotshippedwithSpectraLogiclibraries.
Downloadthesoftwareusingthelinkabove.
2. OpenthefolderandrunIW2_Setup‐v1.1.0.27.exe.Theprogram
searchesthenetworkforanycompatiblenetworkcameras.
3. Whenthediscoverycompletes,agraphicofthedetectedsetup,similar
toFigure241,displays.ClickNext.
Figure 241 Sample detected network.