Spectra T950 - Run the DLM Drive Health Verification Wizard

Chapter 13 — Drive Troubleshooting Using DLM to Test a Drive
November 2016 User Guide—Spectra T950 Library
429
Run the DLM Drive Health Verification Wizard
Usethefollowing stepsto launchtheDLMDriv eHealthVerificationwizard.
1. Logintothelibraryasauserwithsuperuseroradministrativeprivileges.
2. Ifnecessary,importascratchtapeandacleaningcartridgeintothe
library(seeRequirementsforUsingtheWizardonpage427).
3. Fromthetoolbarmenu,selectConfiguration > DLMtodisplaythe
Drivesscreen.
Note: TheTestbuttonisnotpresentifDLMisnotenabled.
4. ClickTestnexttothedriveyouwanttotesttostarttheDLMDrive
HealthVerificationwizard.
Thewizarddetermineswhetheralloftherequirementsforthetestare
met.
All Requirements Met Ifalloftherequirementsforperformingthetest
aremet,theDriveHealthVerificationscreendisplaysawarningabout
theupcomingtestprocess.Proceedto
Step5.
Figure 264 Click Test on the Drives screen to launch the
wizard.
Figure 265 Click Next on the Drive Health Verification screen
to begin the verification process.