Spectra T950 - Configure Mail Users

Chapter 4 — Configuring the Library Configuring the Global System Settings
November 2016 User Guide—Spectra T950 Library
118
5. ClickSavetochangetheIPaddressing.
Notes:  IfyouareconnectedtothelibrarythroughtheBlueScaleweb
interfaceandyouchangetheaddressing,thelibrary’sIP
addresschangesassoonasyouclickSave.Asaresult,you
losetheconnectiontothelibrary.
 Ifyouareusingtheoperatorpanel,selectanyoptiononthe
toolbarmenutoleavetheNetworkSettingsscreen.
Configure Mail Users
Overview Thelibrarycansendemailmessageswithsystemmessages,
traces,anddiagnosticresultstoselectedrecipients.Theserecipientscanbe
configuredtoreceivemessagesautomaticallyastheyaregeneratedbythe
library,orondemandwhentracesarerun,reportsaregenerated,orthe
libraryʹsconfigurationdataisbackedup.Recipientscanalsobeconfigured
toreceiveAutoSupportmessages.
Notes:  ThelibrarymustbeconnectedtoanetworkwithInternet
accessbeforeyouconfiguremailrecipients.
 YoumustconfiguretheSMTPserverusedbythe
autosupport@spectralogic.commailuserifyouwanttoopenan
AutoSupportticketdirectlyfromthelibrary(see
Chapter11–ConfiguringandUsingAutoSupport,
beginningonpage330).Thismailuserisalsousedtosend
theASLandHHMfilesthatthelibrarygeneratestoSpectra
LogicTechnicalSupportwhentroubleshootingaproblem.