Spectra T950 - Configure the Robotic Path Visibility

Chapter 6 — Configuring and Managing Partitions Creating a Storage Partition
November 2016 User Guide—Spectra T950 Library
206
2. Selecttheuserswhoareallowedaccesstothispartition.Onlyusers
whowerepreviouslyconfiguredcanbeselected(seeConfiguring
LibraryUsersonpage101).
Notes:  Alloftheuserswhoareconfiguredwithoperatorprivileges
arelistedunderAllow only.Selectoneormoreoftheseusers
toenablepartition‐basedsecurityforoperators.
 IfyoudidnotconfigureadditionalOperatorlevelusers,you
candosolaterandtheneditthepartitiontogivethemaccess.
 Superusersandadministratorsalwayshavefullaccesstoall
partitions.
Configure the Robotic Path Visibility
RoboticpathvisibilitydetermineswhetheroneorbothoftheFibre
Channelportsontheexportingcontrollerprovidetheroboticcontrolpath
totherobotics.
Usethefollowingstepstoconfiguretheroboticpathvisibility.
1. FromthePartitionUsersscreen,clickNext.TheRoboticPathVisibility
screendisplays.
Important
If you are using a tape drive to provide the robotic control path, this is the last
partition configuration screen. Skip to
Confirming and Saving the Partition Settings
on page 211.
Figure 130 Select the port on the exporting controller that is
used to communicate with the robotics.