Spectra T950 - Configure the System Settings

Chapter 4 — Configuring the Library Configuring the Global System Settings
November 2016 User Guide—Spectra T950 Library
111
Configure the System Settings
Thefollowingtableliststhesystemsettingsthatareconfiguredthrough
theOtherSettingspaneoftheSystemSetupscreen,describeshowto
changeeachsetting,andprovidesthedefaultvalueforeachsetting,if
applicable.
Setting Description Default
Library Name Setthenameusedtoidentifythelibraryinmessagesit
sendstomailrecipients.
1. Typeanameforthelibrary.Useanamethathelps
identifythelibrarytoaremoteuser.
2. ClickSave.
blank
(nonameset)
Web Server Port SettheportnumberforthededicatedEthernetportusedto
accessthelibrary’sembeddedwebserver.
1. Enteraportnumberfrom0to65,535.
Thedefaultportnumberis80,whichisappropriatefor
mostinstallationsandisstronglyrecommended.Ifyou
useaportnumberotherthan80,theportnumbermust
beexplicitlyenteredintothewebbrowserwhen
accessingthelibraryremotely.
Important: Do not set the web server port to 443. Using
this port number causes the front panel display to
become unstable.
2. ClickSave.
3. Resetthelibrarytoenablethenewwebportnumber
setting(see
ResettingtheLibraryonpage368).
80
Refresh Rate SethowfrequentlytheinformationontheBlueScaleuser
interfacescreensisrefreshed.
1. UsetheRefreshdrop‐downlisttoselectascheduled
intervaltime.
2. ClickSave.
Notes:
 Youcanmanuallyrefreshthedisplayedinformationat
anytimebyclickingtherefreshdisplaybuttonlocatedat
theleftendofthestatusbar(see
StatusBaronpage89).
 Ifyouwanttodisableautomaticrefreshingofthedisplay,
settherefreshratetozero.
 Ifyouconfigureasettingotherthanthedefaultrefresh
rateordisableautomaticrefreshing,youmustconfigure
therefreshrateeverytimeyoulogintothelibrary.
60seconds