Spectra T950 - Page 112

Chapter 4 — Configuring the Library Configuring the Global System Settings
November 2016 User Guide—Spectra T950 Library
112
Auto Logout
Timeout
SethowlongthecurrentconnectiontotheBlueScaleuser
interfaceisidlebeforethecurrentuserisloggedout.
1. Enterthenumberofminutesforthetimeout.
2. ClickSave.
Note: Settingthetimeoutvaluetozerodisablesauto
logout.
0(zero)minutes
(Disabled)
Disable Online
Access to Spectra
Logic
DisableorenabledisplayinglinkstotheSpectraLogic
websiteatthebottomofeachBlueScalescreenwhenthe
libraryhasaconnectiontotheInternet.
1. SelecttheDisable Online Access to Spectra Logiccheckbox
todisabletheoption(orclearthecheckboxtoenableit).
2. ClickSave.
Cleared
(Enabled)
Enable Drive
Performance
Monitoring
Enableordisabletheoptiontomonitortheperformanceof
thedrivesinthelibrary(seeViewDrivePerformance
Statisticsonpage166).
CAUTION: Make sure that the drives do not contain
media before you enable or disable Drive Performance
Monitoring. If you enable or disable this option when a
drive contains a cartridge, the drive is reported as empty
and backups may fail.
1. SelecttheEnable Drive Performance Monitoringcheckbox
toenabletheoption(orclearthecheckboxtodisableit).
2. ClickSave.
Cleared
(Disabled)
Enable Power
Consumption
Monitoring
Enableordisabletheoptiontomonitortheamountof
poweryourlibraryisusingthroughthePower
ConsumptionMonitor(EnergyAudit)feature(seeView
PowerConsumptionStatisticsonpage168).
1. SelecttheEnable Power Consumption Monitoringcheckbox
toenabletheoption(orclearthecheckboxtodisableit).
2. ClickSave.
Note: Whenyoudisableandthenre‐enablepower
consumptionmonitoring,thelibrarydoesnotbegin
capturingdataagainuntilyoupowercyclethelibrary.
Selected
(Enabled)
Enable Automatic
Power-Up After
Power Failure
Enableordisabletheoptiontoautomaticallypoweronthe
libraryafterapowerfailure(seeUsetheAutomaticPower‐
UpAfterPowerFailureFeatureonpage159).
1. SelecttheEnable Automatic Power-Up After Power Failure
checkboxtoenabletheoption(orclearthecheckboxto
disableit).
2. ClickSave.
Note: TheEnableAutomaticPower‐UpAfterPowerFailure
featurecanonlybeenabledordisabledby asuperuser.
Cleared
(Disabled)
Setting Description Default