Spectra T950 - Page 159

Chapter 5 — Operating the Library Controlling the Library Power
November 2016 User Guide—Spectra T950 Library
159
Use the Front Panel Power Button
1. Pressandholdthefrontpanelpowerbuttonuntilthebutton’sLED
illuminatesandtheLCDoperatorpanelturnson.
2. Waitwhilethelibrarycompletesitspower‐onsequence.Afterthe
librarycompletesitspower‐onsequence,theLibraryInitialization
screendisplays(seeFigure49onpage93).Thisscreenliststherequired
initializationstepsandcurrentstatusofthelibrary’smajorcomponents
(Robotics,RCM,andLCM).Textboxesprovidedescriptionsaboutthe
currentlyactivetasks.
3. Afterinitializationiscomplete,theBlueScaleloginscreendisplays(see
LogIntotheUserInterfaceonpage93).
Note: Ifthelibrarycannotcompletetheinitializationprocess,it
generatessystemmessagesandentersmaintenancemode.
ContactSpectraLogicTechnicalSupportforassistance.
Use the Automatic Power-Up After Power Failure Feature
TheAutomaticPower‐UpAfterPowerFailurefeatureletsyouconfigure
thelibrarytopoweronwithoutuserinterventionafterapowerfailure.
Notes:  TheAutomaticPower‐UpAfterPowerFailure featuremust
beenabledontheSystemSetupscreen(see
Enable
AutomaticPower‐UpAfterPowerFailureonpage112).
 Thelibrarydoesnotautomaticallypoweronifitwaspow ere d
offusingthefrontpanelpowerbuttonortheSoft Powerfeature.
Figure 93 Press and hold the front panel power button.
Power button