Spectra T950 - Determine Whether Cleaning is Required

Chapter 15 — Maintaining the Drives Cleaning a Drive
November 2016 User Guide—Spectra T950 Library
462
Determine Whether Cleaning is Required
Cleanthelibrary’sdriveswhenanyofthefollowingoccurs:
 Thedriveindicatesthatitneedscleaning(seeChapter13–Drive
Troubleshooting,beginningonpage394)bysendingamessagetothe
storagemanagementsoftware.
 TheDriveDetailsscreenindicatesthatthedriveneedscleaningor
displaysaContheSCDforanLTOdriveorCLEAN* ontheMCDfora
TS11x0technologydrive(seeFigure298onpage463).
Note: Inorderforthelibrarytomonitordrivestatus,thedrivemustbe
configuredinapartition.
UsethefollowingstepstousetheDrivesscreentodeterminewhethera
driverequirescleaning.
1. Logintothelibraryasauserwithsuperuseroradministrator
privileges.
2. SelectConfiguration > DrivesorConfiguration > DLMifMLMis
enabled.TheDrivesscreendisplays.
Figure 297 Click Detail on the Drives screen.